The car battery, usually lead acid, is 12 volts with six 2 volt cells connected in series and marine batteries, usually deep cycle, are expensive items to replace. The main cause of damage to lead acid batteries is when they are left to sit for a long period of time.
Weather is the main factor in any marine battery failure. Car batteries suffer the same when the car is stored or not used for months.
Adding a battery additive when new will extend the life of the car battery and the battery will have a better response to reconditioning.
Each automobile and marine battery has a limited lifespan to operate the electrical power systems in the automobile or boat with the highest level of efficiency.
THE DEAD BATTERY EFFECT.
Battery efficiency decreases when overused and typically slowly decreases due to sulfation on the battery plates, which is the most common cause of decreased battery performance in lead-acid batteries. automotive acid.
Sulfation occurs when sulfur builds up on the battery’s lead plates, blocking electrical current. It is not difficult to recondition your car battery at home by following a guide.
This stops the production of electricity that passes between the plates and that is when the battery needs to be restored or reconditioned.
QUICK FIX
“Epsom salts, distilled water and a voltmeter. Sulfation causes irreversible corrosion of the lead plates, so this process will only work a couple of times. It’s a simple process to try to get the battery to work again.”
Test your car battery to see if it responds to reconditioning. To recondition a car battery at home, you must register 12 volts on a voltmeter.
The car battery has a reading of between 10 and 12 volts, you may be able to restore the battery to full working, 10 volts or less, you most likely have a cell [2 volts] Collapsed and reconditioning the battery can be a waste of time.
BAIL:
1. Car batteries contain sulfuric acid, which is dangerous for humans and the environment.
2. Work only in a well-ventilated area.
3. Do not work near or near open flames.
4. Wear safety glasses and rubber gloves.
5. If acid gets on your skin, wash it off immediately with plenty of water.